MP430 breakout board. TQF64 to LQF64 Breakout. The pin spacing of LQF64 is 2.54mm (0.1').

Basic breakout board for the TEMT6000 Ambient Light Sensor. Only what you need, nothing you don't. Sensor acts like a transistor - the greater the incoming light, the higher the analog voltage on the signal pin. Documents: Datasheet Wiring...

6 pin SOT-23 to DIP adaptor. Created to take SOT23 of various pin sizes breakout to DIP. This will work with 3-pin MOSFETs, BJTs, Voltage Regulators (SOT-23-5), and various other Micro6, Micro5, etc packages.  DIP width is 0.300" (300mil) and will...

This board does the 3.3V to 5V translation. So you can direcly plug it to Arduino. The Vcc of this board is 5V!   Why? Arduino has 512 bytes EEPROM (which does not loose its contents at power off) and 1024 bytes RAM (which contents are lost at...

Through-hole RJ15 socket with PCB mounting posts. 8-pin connection - housing accepts common Cat5, Cat5e, and Cat6 Ethernet cables. The breakout board and male header are included.   Download: RJ45 connector datasheet

This is a simple to use, Xbee USB adater. This unit works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. Plug the unit into the XBee USB adapter, attach a mini USB cable, and you will have direct access to the...

Breakout board for the microSD socket that is not much bigger than your fingernail. Compatible with the SPI interface found on any SD card, this tiny form factor was created for cell phone storage and is perfect for your next MP3 project! Board comes...

This is the breakout board for the joystick very similar to the 'analog' joysticks on PS2 (PlayStation 2) controllers. Directional movements are simply two potentiometers - one for each axis. Pots are ~10k each. This joystick also has a select button...

Specification:     Size: 44mm X 23mm X 1.6mm It has 4 fixture holes with a diameter of 3.1mm. The cell battery used is CR2032. Note: the battery is NOT included due to expess mail regulation. Crystal: 32.768KHz. Voltage: 3.3V/5V.

This is a 2-axis joystick module is styled after a PS2 analog stick. It has an X/Y 2-axis analog output and Z-axis single digital output channel button. The joystick is a combination of 2 analog potentiometers and a digital switch.   Test Code //...

This is a simple breakout board for the popular XBee product from Digi. This board breaks out all 20 pins of the XBee to a 0.1" standard spacing dual row header. The spacing between 0.1" headers is 0.5" making it breadboard DIP friendly...

This is a simple, but extremely handy board to adapt the common 10-pin ISP programmers to the smaller 6-pin ISP connections. We also designed in a 6-pin inline connector so that you can insert this board directly into a breadboard!